(Essentially Similar to OSHA-20)
Tampa, FL 33605
1-866-829-6908
|
I – PRODUCT IDENTIFICATION CHEMICAL LABORATORIES INC. |
|
|
MANUFACTURER’S NAME AND ADDRESS 1917 E. HEMLOCK AVE TAMPA, FL 33605 |
|
|
CHEMICAL NAME Tar / Wax Remover |
CHEMICAL FORMULA PROPRIETARY |
|
TRADE NAME AND SYNONYMS
|
CHEMICAL FAMILY AROMATIC & ALPHATIC SOLVENTS |
|
CAS REGISTRY NO.
|
DOT IDENTIFICATION NO. |
|
II – HAZARDOUS INGREDIENTS |
||
|
MATERIAL OR COMPONENT Compounded solvents, generally classified as “moderately toxic”. |
%(wt) 100 |
PEL (Units) 200
|
III = PHYSICAL DATA |
|
|
BOILING POINT (°F) 350 – 410 |
SPECIFIC GRAVITY 0.880 – 1.000 |
|
VAPOR PRESSURE (mm Hg) 0.5 mm Hg @ 68°F |
PERCENT, VOLATILE BY VOLUME (%) 100 |
|
VAPOR DENSITY(AIR=1) 4.58 |
EVAPORATION RATE 0.02 |
|
SOLUBILITY IN WATER NEGLIGIBLE |
APPEARANCE AND ODOR CLEAR |
|
IV – FIRE AND EXPLOSIVE HAZARD DATA |
|
|
FLASH POINT (Method used) TCC 147 °F |
FLAMMABLE
LIMITS Lower Upper 0.5 6.0 |
|
EXTINGUISHING MEDIA Water spray – CO2 – Foam – Dry Chemical |
|
|
SPECIAL FIRE FIGHTING
PROCEDURES NONE |
|
|
UNUSUAL FIRE AND
EXPLOSION HAZARDS NONE |
|
|
V – REACTIVITY DATA |
||||||
| STABILITY |
UNSTABLE
|
X |
CONDITIONS TO AVOID Heat, sparks, open flames, and fire |
|||
|
STABLE
|
||||||
|
INCOMPATIBILITY (Material
to avoid) Strong oxidizing agents |
||||||
|
HAZARDOUS DECOMPOSITION
PRODUCTS Thermal decomposition may yield carbon monoxide |
||||||
| HAZARDOUS POLYMERIZATION |
MAY OCCUR
|
CONDITIONS TO AVOID
|
||||
|
WILL NOT OCCUR
|
X |
|
||||
|
VI = HEALTH HAZARD DATA
|
||||||
|
OSHA PERMISSIBLE EXPOSURE
LIMIT 200 |
||||||
|
|
||||||
|
EFFECTS OF OVEREXPOSURE
|
||||||
|
INHALATION Excessive inhalation causes headaches, dizziness, and nausea |
||||||
|
SKIN CONTACT /
ABSORPTION Drying of skin
|
||||||
|
EYES: Severe eye irritant
|
||||||
| EMERGENCY AND FIRST AID PROCEDURES | ||||||
|
EYES AND SKIN Flush with plenty of water – rinse other areas with mild soap and water. |
||||||
|
INHALATION Remove to fresh air and call Physician; apply artificial res. If needed |
||||||
|
INGESTION
|
||||||
|
VII – SPILL OR LEAK PROCEDURES
|
|
STEPS TO BE TAKEN IN CASE
MATERIAL IS RELEASED OR SPILLED Flush with water into retaining area or container. Avoid exposure to spark, fire or hot metal surfaces
|
|
WASTE DISPOSAL METHOD Incinerate under safe conditions or dispose of in accordance with local, state, and federal regulations. |
|
VIII – SPECIAL PROTECTION INFORMATION
|
|
SPECIFIC PERSONAL
PROTECTIVE EQUIPMENT RESPIRATORY Local exhaust |
|
EYE Yes eye bath |
|
SKIN Safety shower |
|
OTHER
|
|
VENTILATION REQUIREMENTS Self contained breathing apparatus for concentrations above TLV limit |
|
IX – SPECIAL PRECAUTIONS
|
|
PRECAUTIONS TO BE TAKEN
IN HANDLING AND STORING Keep away from heat, sparks, and open flame. Use with adequate ventilation. Avoid prolonged or repeated contact with skin. |
|
OTHER PRECAUTIONS
|